|
||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||
| SIDEWINDER
|
|
|
|
Sidewinder-3LT:
Three 0.036" blades, 85 grains, and 1 1/2" cutting diameter. The
Sidewinder-3 Lite is the Sidewinder-3 without the Pathfinder point. The
blades are interchangeable with the Sidewinder-3 and 4 and they are also
0.036" thick which is thicker than the other Aerohead blades. Thicker blades
mean less bending and a more reusable head. Recommended for launch speeds
over 220 ft/sec.
|
 |
Sidewinder-4LT:
Four 0.036" thick blades, 88 grains, 1 1/2" cutting diameter, and 1/2" in
flight. The Sidewinder-4 Lite is the Sidewinder-4 without the Pathfinder
point. It has the same hardened steel chisel tip as the other Aeroheads,
which creates a hole plenty wide for shafts which are thinner than the
ferrule. The blades are cut from the same die an those of the Miniblaster-3L
but they are thicker and not interchangeable
|
 |
Sidewinder-3:
100 grains, 1 1/2" cutting diameter, with three 0.036" thick blades. The
SideWinder-3 is built for penetration. The blades angle further back than
the other Aeroheads and it is tipped with our new Pathfinder cut-on-impact
sharpened steel point. The extra wide cut made by the Pathfinder point means
less shaft resistance and deeper, deadlier penetration, especially with
larger diameter aluminum shafts.
|
 |
Sidewinder-4: 103 grains, 1 1/2" cutting diameter, with four 0.036" thick blades. The Sidewinder-4 has the same construction as the Sidewinder-3 with the same extra thick blades and Pathfinder point. The deep concave cut of the Pathfinder point concentrates a lot of bone-shattering force on a small surface area to break up bone efficiently before the blades strike. The recommended launch speed is 220 ft/sec or greater |
| HAMMERHEAD
|
|
|
|
Hammerhead-3L:
Exactly 100
grains, 2" cutting diameter, 3/7" in flight,with three 0.027"stainless steel
blades. The Hammerhead=3L is essentially a larger verison of the
Miniblaster-3L. The O-ring is positioned further forward (making it a
little stiffer to open) and the blades are angled back slightly more. A
launch speed over 260 ft/sec will ensure a full width entry wound and
optimum penetration. Below 260 ft/sec the O-ring can bwe moved back behind
the blade notch (about 1/8" to the next small notch) for a quicker opening.
|
 |
Hammerhead-4L:
108 grains, 2" cutting diameter, 3/8" in flight, with four 0.027" stainless
steel blades. The Big-X-Bullet of archery, the Hammerhead-4L was created to
harness all the power of today's high performance bows. It delivers an
enormous 4" of horizontal cut, yet it will out-penetrate many conventional
vented broadheads of considerably smaller size. The blades are swept back
for superior penetration. The recommended launch speed is for 260 ft/sec or
greater.
|
|
|
|
